Loading... Please wait...

How to refill Lexmark MS310dn, MS310d, MS410d, MS410dn, MS510dn, MS610de, MS610dn, MS610dte, MS610dtn Dell B2360d, B2360dn, B3460dn, B3465dn toner cartridges

Posted by


How to refill Lexmark MS310dn, MS310d, MS410d, MS410dn, MS510dn, MS610de, MS610dn, MS610dte, MS610dtn 

Dell B2360d, B2360dn, B3460dn, B3465dn toner cartridges

REQUIRED TOOLS

1.     Phillips screwdriver

2.      Jeweler's type Phillips screwdriver

3.      Small flat screwdriver

4.      Hook tool for spring removal (optional)


REQUIRED SUPPLIES

1.     New, replacement toner for use in Lexmark,Dell Series MS/MX cartridges, with designated gram load

2.      Replacement chip for toner cartridge, with proper yield and corresponding regional setting



1. Remove the three screws of the right-side end cap of the 2. Carefully pry open the end cap while holding the push-plate toner cartridge. steady to avoid dropping it.


2. Carefully pry open the end cap while holding the push-plate steady to avoid dropping it.



 3. Remove the end cap holding your finger on the small plastic



4. Remove the spring at the end of the arm, and lift to remove arm indicated by the arrow. It is possible that the pushing-rod it from the sliding support. of the toner-exit lid could come loose, requiring proper seating adjustment during assembly to function properly.


5. Apply leverage with a small screwdriver on the edges of the fill plug to be able to pry it all around, be sure to apply force to the plug itself, and not where it is seated. Fortunately the plug is made of a softer silicone-like material that helps minimize damage when removed.

6. Remove the fill plug



7. Empty the hopper/cartridge and clean thoroughly by using a vacuum.. This step is very important; better cleaning of the cartridge and not mixing previous toner with new toner, the better quality printing result.


8. Fill with the appropriate amount of toner for the proper yield.


9. Replace the fill plug and check for leaks.

 10. Remove the chip by first removing the two screws securing the holder inside the end cap


11. Unscrew and separate the chip from the holder.



12. Install the new chip and assemble the cartridge following


13. Install the push-plate into the sliding guide and insert the the previous steps in reverse order. tip of the arm inside it.


14. Position the spring on the punch-plate and hook one end



15. The installation of the complete assembly must be to the fixed post in the cartridge, and the other end in the top completed as shown in the photo. end of the push-plate.Secure the end cap with the three Phillips screws. cartridge to avoid displacement, position the end cap to be seated in its final place.





Check to make sure the closing and opening of the toner . By manually pressing the arm (as shown in the photo) outlet system functions properly. Without pressing the or by inserting the cartridge in the machine, the outlet lid must front plate, the toner outlet must remain closed all the time. open and close when released.




When the front cover of the machine is closed it pushes the plate all the way in and allows the toner feeding to be ready.



Video Section






comments powered by Disqus

 

What's News

newsletter

Follow us on

Copyright 2019 TM-toner.com. All Rights Reserved.
 Sitemap |